Container
/ Tank:
Self-supporting container in cylindrical form. The container is made of a rustproof
chrome-nickel-steel. Material V2A / V4A, cold rolled sheet metals, smooth surface.
The joints are smoothed from the inside. The tank will be pickeled from the
inside.
Bucks, bandages and space rings within the isolation are made of high-grade steel.
Chassis:
Three-axle aggregate, a nearly maintinance-free version, air-cushioned, including
a steering axle and/or a lifting axle.
Tyres:
Sixfold tyres
Size: 385 / 65 R 22.5
mounted on disc wheels
light-metal rims on request
Semi-Coupling-Top:
In the front at the bottom of the container you can find the semi-plate with
kingbolts 2".
Brake-System:
Electronic-Brake-System, including a 4-channel-ABS-system, parking brake which
works on two axles, disk brakes on request.
Wheel
covering:
Plastic mudguards
Aluminium mudguards on request
Mudcatcher which are made of plastic
Support-Winding-Component:
A mechanical support-winding-component , nearly maintinance-free, 24.000 kg
load capacity
Heating:
At the bottom of the container you can find a pressureless heating sump with
two channels, made of high-grade steel, to connect it with the exhaust pipe
and to operate it under steam; without a powered unite facility.
Tube
carrying:
At the side of the container you can find two of them.
Tubepipes NW 150 , for 3"-tubes, each has a length of 8.000 mm
Isolation:
The hole container will be equiped with a 100 mm fiber-glass isolation. The
external case is made of VA- or GfK-ways; final grounds are made of GfK
Space rings and space holders within the isolation are made of high-grade
steel.
Gangway
/ ascent:
The gangway is mounted on the entire length of the container; the gangway is
made of safety gratings, it is equiped with a collapsible hand-run which is
made of aluminium.
A scissor-railing is servible from below. You can find walking gratings between
the domes in the middle of the tanks. You can find a ascent ladder at the end
of the vehicle.
Reject-tube:
You can find at the right and at the left side a reject-tube which is mounted
on the entire length over the container. (direction of motion).
Electrical
installation:
The complete installation is done in a ex-secured version, it is done according
to the prescription of the StVZO;
Including outline lamps
Lacquer:
The lacquer of the semi-trailer is made of acrylic-lacquers.
Accessories:
1 bumper including a sub-drive-protection
1 Toolcupboard
- Thermometer
2 drags including the holders
1 space wheel holder
Special-accessories:
hotwater heating system
Acceptance:
All weights and standard declarations should be understood as approximate merits. Technical changes are reserved for futher developments.