Self-supporting container in cylindrical form which is tested in explosion-, pressure- and impact stability.
The container is made of a rustproof chrome-nickel-steel. Material V2A / V4A and special high-grade steel, cold rolled sheet metals, smooth surface. The joints are smoothed from the inside. The tank will be pickeled from the inside.
Bucks, bandages and space rings within the isolation are made of high-grade steel.
Three-axle aggregate, a nearly maintinance-free version, air-cushioned, including a steering axle and/or a lifting axle.
Size: 385 / 65 R 22.5
mounted on disc wheels
light-metal rims on request
In the front at the bottom of the container you can find the semi-plate with kingbolts 2".
Two-Line-Compressed-Air-Brake-System, including a 4-channel-ABS-system, parking brake which works on two axles, disk brakes and electronical suspension / brake system on request.
Aluminium mudguards on request
Mudcatcher which are made of plastic
A mechanical support-winding-component , nearly maintinance-free, 24.000 kg load capacity
At the bottom of the container you can find a pressureless heating sump with two channels, made of high-grade steel, to connect it with the exhaust pipe and to operate it under steam; without a powered unite facility. Pressure heating on request
At the side of the container you can find two of them.
Tubepipes NW 150 , for 3"-tubes, each has a length of 8.000 mm
The hole container will be equiped with a 100 mm fiber-glass isolation. The external case is made of VA- or GfK-ways; final grounds are made of GfK
Space rings and space holders within the isolation are made of high-grade steel.
Gangway / ascent:
The gangway is mounted on the entire length of the container; the gangway is made of safety gratings, it is equiped with a collapsible hand-run which is made of aluminium.
A scissor-railing is servible from below. You can find walking gratings between the domes in the middle of the tanks. You can find a ascent ladder at the end of the vehicle.
You can find at the right and at the left side a reject-tube which is mounted on the entire length over the container. (direction of motion).
The complete installation is done in a ex-secured version, it is done according to the prescription of the StVZO;
Including outline lamps
The lacquer of the semi-trailer is made of acrylic-lacquers.
1 bumper including a sub-drive-protection
- cipher board incl. ciphers
- hazard signs
1 fire extingguisher 6 kg including the holders
2 drags including the holders
1 space wheel holder
compressor and pump,
hotwater heating system,
All weights and standard declarations should be understood as approximate merits. Technical changes are reserved for futher developments.